This is the newest generation Reagent frame...
It may look very similar to the old Regaent frame but every curve and joint has been redesigned. A new manufacturing jig has been produced to make the frame squarer. Just looking at the frame you can see that there is a dramatic increase in quality over what was already one of the top street/flatland frames available. The Frame is made from 6061 T6 Aluminum and requires the new (32mm) bearings. The only change you will need to make to convert your existing hub to fit this frame is to change the outer bearing spacer from 6mm to 5mm.
*The exception is hubs fitted with Kris Holm Moment cranks. These require 6mm spacers instead of the original 8mm.
*These frames will only run ISIS 32mm Bearings, you will need to convert your hub to 32mm bearings to fit this frame.
Length of seat tube: 230mm
Material: 6061 series aluminum
Inside diameter seat tube: 27.2mm (seat post diameter)
Outside diameter seat tube: 31.8mm (clamp inside diameter)
Diameter Bearing holder: 32mm (bearing outside diameter)
Bearing pitch: 100mm (center bearing to center bearing)
Weight: 610g (incl. bearing holders and bolts)
Comes with: bearing housings, screws, seat clamp & 32mm bearings.